Maidens of the Kaleidoscope
~Hakurei Shrine~ => Help Me, Eirin! => Tech Support => Topic started by: Darkblizer on May 03, 2009, 08:12:41 PM
-
It's odd. Danmakufu works fine, too, I'm using applocale, but whenever I run config.exe applocale or not, it'll load for a bit but then won't pop up a window or anything. And if I check, config.exe is running in my Processes. Can anyone help me figure this out?
-
config.exe does not need applocale to run. I usually have to wait a few seconds before it pops up on my screen, but you might want to try redownloading Danmakufu, or downloading an older version of th_dnh just for the config.exe (should be the same, as far as I know. Just don't go back too many versions). Be sure to save your scripts elsewhere if you try redownloading.
What exactly are you looking to accomplish with config.exe anyway? For the most part I've never had to use it, save for trying to record rediculus amount of bullets on fraps or something, so I limit my draw fps to conserve some processing power.
Optionally (nevermind, this was foolish).
-
Right click it and go to properties and compatibility. Then check run in compatibility mode for... and open up the drop down menu and select windows 2000.
This works for me on XP but I don't about Vista.
-
Right click it and go to properties and compatibility. Then check run in compatibility mode for... and open up the drop down menu and select windows 2000.
This works for me on XP but I don't about Vista.
Thanks, this worked. I'm running on XP.